Zitat:
Zitat von freaky930
hey tgr
on page two of this thread it is explained (in german but) how it was done in short.
the whole lower frame needs to be altered and adjusted to meet the chassisgeometry of the original bike to make it work properly.
If you get it done plug 'n play, please let us know!!
|
thank you freaky930,
The swingarm itself was simply plug n play with the addition of a custom stainless steel spacer which also took care of the sprocket alignment.
The only thing that I can't get plug n play was the nc30's lower linkage mount, I worked out a way to simply make afew cuts in the dogbone connecting shaft and use spacers and new needle bearings to mount it to the GS frame.
But it still needed afew tabs welded on for outer dogbones, so I decided to simply remove the gs's mounts and center stand and just go with a new bracket that will be bolted and welded into place. Once i gte it all mounted and welded into place I'll start a topic and post some piccys
